3x5.25 Hard Drive Cage - 5x3.5" drives

A simple remodel, I did not take my time, but I spaced it out a bit to support 5 3.5" drives instead of 4 like the original model.

I have computers that use the IcyDock FatCage, which supports 5 3.5" drives. I found this model when setting up another server and took the liberty to make an edit.

Included a model with cutouts to save print time and filament and one without filament savings. Please get the original Sled Guides and other Fan parts for the OG Post.

Additional Files (Original Post):

https://www.printables.com/model/120546-3-x-525in-bay-to-four-35in-hard-drives-cage

I included a simple print test to ensure it works for your Hard Drives, but I tested it with several Hitachi Ultra, WD Blue/Red/Purple/Gold, and Seagate Ironwolf for spacing.

EDIT: I would print the rails 98% on the Z/X, retaining the length as the same size. This helped any tight tolerances depending on your printer on the cage print.

I printed the cage with a 0.4 nozzle at 0.28mm height and 0.48 width setting on my CR10S Pro v2.

EDIT2: Moved from a Rosewill Thor V2 Full ATX that had 6x5.25" to a Rosewill L4500 4U with 9x5.25 and have 15x3.5 layout. See included pictures. I did not install the front fans. I have 3x140mm Noctua Performance fans (Mid-Chassis Server Style) creating negative pressure, and it works fine when the lid is closed. I saw 42-45C during a parity check on Unraid pulling a lot of IOPS; otherwise, drive spin-down options have been enabled after 60 of idle. I see no issues with anyone using this option if they have decent ambient temps and proper fan cooling.

MatterHacker Build PLA Gray/Black.