1 / 4
Tool tray for Feedback Sports bike stand — image 1
1 / 4

Tool tray for Feedback Sports bike stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Designed by Scot Jaworski of Escape Collective - tool tray for Feedback Sports bicycle stand with provision for magnets.

Rating
5 / 5
Likes
34
Downloads
190
Makes
3
Views
1,991
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Printable version of Scot's tray stand that he made in wood. Designed to work with magnets on the side and drop onto the top of the Feedback Sports stand - or any stand with a 38mm top post.

Magnets link - 80x13.5x5mm with countersunk screws on 71.3mm centers. Mount the magnets with #6 wood screws no longer than ½" - otherwise they will stick into the storage bins and likely cut your fingers when you reach in.

Printing

Strongly recommended to print the “TEST- feedback stand shaft fitment” part first to make sure your printer is properly calibrated and doing the center hole at the right size. The hole is sized to fit over the center post with minimal slop, so if your printer does holes a little undersized it might not fit.

Pretty much whatever you want, filament, layer height, etc. Very little vertical detail so very little need for fine layer heights, crank it up to the maximum and save print time.

Note for anyone printing on an Ender 3 with 235mm square bed - rotate the part 45 degrees and auto locate it, and you should wind up with a few mm of clearance.

Tags