1 / 5
Elgato Wave 3 Horizontal Low Profile Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tuck your Elgato Wave 3 under your monitor without blocking your view! Reduces height by half. Uses stock hardware.
- Rating
- 4.5 / 5
- Likes
- 13
- Downloads
- 169
- Makes
- 2
- Views
- 1,094
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mic stand adapter that enables you to mount your Elgato Wave 3 horizontally. This is especially useful for those who keep their mic under their monitor or in other places where a lower-profile mic is desired.
Hole on top for DIY expandability (be sure to link your models as a remix!):
- Camera stand
- Flat surface
- Gridfinity baseplate
- Ring light
- Second mic
- Decorative print (a cat or a nice finial)
- Handle
- Macro pad
Print:
- Print with the “back” down as pictured. No supports needed. Brim optional.
- Tolerances are fairly tight, but just right for a BambuLab X1.
- It's okay if the top of the circular indentation sags a bit, this is by design (the mic has a flat spot at the mating location)
Use:
- Remove the original bracket from the stand and the mic
- Install the new bracket to the mic using the original thumb screws
- Push the new bracket onto the post of the original base
- Screw the new bracket it into the ¼-20 stud at the top of the base's post
- You may need to push the bracket in while turning
- If you put the knob on the right side then the LED's indicate value from the bottom (min) to the top (max)