1 / 5
Elgato Wave 3 Horizontal Low Profile Stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tuck your Elgato Wave 3 under your monitor without blocking your view! Reduces height by half. Uses stock hardware.
- Ocena
- 4,5 / 5
- Polubienia
- 13
- Pobrania
- 171
- Wydruki
- 2
- Wyświetlenia
- 1100
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (1)Kolekcje (16)Powiązane
This is a mic stand adapter that enables you to mount your Elgato Wave 3 horizontally. This is especially useful for those who keep their mic under their monitor or in other places where a lower-profile mic is desired.
Hole on top for DIY expandability (be sure to link your models as a remix!):
- Camera stand
- Flat surface
- Gridfinity baseplate
- Ring light
- Second mic
- Decorative print (a cat or a nice finial)
- Handle
- Macro pad
Print:
- Print with the “back” down as pictured. No supports needed. Brim optional.
- Tolerances are fairly tight, but just right for a BambuLab X1.
- It's okay if the top of the circular indentation sags a bit, this is by design (the mic has a flat spot at the mating location)
Use:
- Remove the original bracket from the stand and the mic
- Install the new bracket to the mic using the original thumb screws
- Push the new bracket onto the post of the original base
- Screw the new bracket it into the ¼-20 stud at the top of the base's post
- You may need to push the bracket in while turning
- If you put the knob on the right side then the LED's indicate value from the bottom (min) to the top (max)