Mass Effect Spectre Logo Magnet
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.89 – €1.08 net (excluding VAT)
For file: spectre-logo.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.98 excluding VAT (range midpoint).
- Weight reported by the author
- 13 g
- Print time reported by the author
- 57 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
You can glue a 10 x 1.5 mm round magnet in the base.
- Rating
- 0 / 5
- Likes
- 35
- Downloads
- 110
- Makes
- 0
- Views
- 530
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
You can glue a 10 x 1.5 mm round magnet in the base.
Print instructions
Recommended infill angle: 90°
Low speed and high temperature will create a shiny top surface.
There are "holes" inside the model to make some of the top layers more uniform, and they were created with 0.2 layer height in mind.
If your top surface is not flat & shiny and you see scarring, then make sure to check this guide: https://bit.ly/2UtN0I1