The Owl House Market (Middle)

This is a model of the middle section of the Bonesborough Market from The Owl House. This is a continuation of an earlier model The Owl House Market and the last two images show both combined.

This model consists of 11 structures. These are:

• Bounty stall
• Egg bus stop
• Tomestone building
• (unnamed) middle building
• Teleport Scrolls stall
• Harmony Crystals stall
• green corner stall
• Private Inspectergator stall
• Just Skulls stall
• Human Collectibles stall
• Big Blobs stall

The images show the stalls arranged as they appear in the show, with one exception. The stalls Private Inspectergator, Just Skulls, Human Collectibles, and Big Blobs don't appear to be where I've placed them. I've put them there because I had to fill this space with something.

Print Instructions

Printed at 0.1mm layer height.

Most structures require supports. These are “toh market-bounty stall”, “toh market-egg stop”, “toh market-teleport scrolls”, “toh market-private inspectergator”, “toh market-just skulls”, “toh market-human collectibles”, “toh market-big blobs”. I've used organic supports.

The structures “toh market-tomestone”, “toh market-middle house”, and "toh market-green corner stall" do not need supports. If you enable supports for these, your slice will probably add a bunch of supports which are unnecessary, difficult to remove, and waste filament.

I reduced the overhang threshold to 30°. It's quite low, but works fine with this model and reduces unnecessary supports.

If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#