Hotend Spacer CR10 V3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made a spacer to accommodate another blower setup (read main)
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 77
- Makes
- 1
- Views
- 588
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
After purchasing my CR10-V3 I decided I wanted a better blower setup. I found this one and gave it a spin however after attaching it there was little room for error or adjustment when positioning the mount and as a result it created a little pressure which “canted” the mount
https://www.thingiverse.com/thing:4785446.
In turn I created a spacer to push the mount out about 2mm. I have tested it and so far it seems to be working fine using the above blower setup.
I would suggest more than 70% infill (more solid is better) and 3 perimeters with a .15 layer height.
Note: the round section is to be placed downward to help give a little more stress support from the hotend and blower mount.