Tesla / Tuya Weatherstation sensor holder - Držák senzoru meteostanic Tesla / Tuya
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for the strap, that was originaly included. Náhrada za řemínek, který byl původně v balení.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 19
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
I bought a smart weatherstation and the sensor comes only with a strap to hang it up somewhere.
There persists problems with curling due to overhangs on both sides, so i experimented with speed., temp. and other settings, but in the end i had to realize, that a antiwrap support is the best solution to keep the print nice (rounded) and in a acceptable speed.
The anticurl supports are only 0,42mm thick and can be easily removed after printing.
To make it easier for you, i uploaded a STEP file for your experiments and a 3mf file with my latest stable presets → first 5 mm with 0,1mm layer height, 2mm brim and some speed and temp. tunings.
I used PETG Prusament filament, 0,4 nozzle, printed on textured bed.
*CS
Koupil jsem chytrou meteostanici a v balení byl pro upevnění, nebo spíše pověšení sensoru pouze řemínek.
Kvůli převisům na obou stranách přetrvávají problémy s curlingem, proto jsem experimentoval s rchlostmi, teplotami a jiným možnostmi až jsem si nakonec uvědomil, že nejlepší řešení bude modelu dodat antiwrapové podpěry, díky kterým zachovám model hezký (zakulacený) a bude se tisknout v přiměřeném čase.
Podpěry jsou pouze 0,42mm široké a lze je jednoduše po tisku odstranit.
Abych vám to unsadnil, uploadoval jsem STEP soubor pro vaše experimenty a 3mf soubor s mými posledními, nejlepšími přednastaveními. → prvních 5mm nastavena vrstav 0,1mm, 2mm límce, a nějaké to dolazení teplot a rychlostí.
Použil jsem PETG Prusament filament, 0,4 mm trysku, tisknuto na texturované podložce.