1 / 2
608RS Bearing Fit Tester — Calibrate 3D printed pins to fit perfectly with your printer — image 1
1 / 2

608RS Bearing Fit Tester — Calibrate 3D printed pins to fit perfectly with your printer

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Quickly get the perfect fit on 3D printed parts that interface with common 608RS skateboard bearings.

Rating
0 / 5
Likes
4
Downloads
60
Makes
0
Views
416
Reviews
0

Updated at source:

Model information

Category
Test Models
License
Creative Commons — Attribution — Share Alike

Note: photo shows an earlier version of this print without the numbers. The model includes them for convenience, though.

This is a simple, lightweight print with 8 pins ranging from 7.85mm in diameter to 8.2mm in diameter, spaced far enough apart that a standard 608RS skateboard bearing will fit over the pin. To use it, simply slide the bearing over each pin starting on the lower left and going toward the top right until you find the perfect fit for your project. Adjust your design to match the indicated pin diameter and you should have a perfect fit.

Note: print the pin test in the same orientation, with the same material, on the same printer that you intend for your design to be printed in. Different printers vary in the extrusion width. Similarly, filaments vary, especially between material types. Inexpensive filament can also drift in the material diameter over a spool or in between spools, so it may be useful to run a fresh calibration print if you have this issue.

This tool is only useful for the pin diameter. In my experience, using a 22.1mm diameter for the outer diameter of the bearing provides a very snug fit without breaking in PLA and PETG, so I haven't needed to create a calibration tool for that purpose. I may in the future if my luck runs out, though!

Tags