eSun Vaccum Bags Eibos Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
eSun vacuum bags adapter (and spacer) for Eibos pump (remixed).
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 91
- Makes
- 0
- Views
- 774
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Adapter to use the Eibos electric pump on the eSun vacuum bags, also acts as a suction aid to separate the valve from sticking the bottom of the bag for easier suction.
How to use:
Place the adapter inside the bag below the valve (round opening facing the value, of course), The adapter stays in the bag under vacuum, so get ready to print more.
Note: Not sure if needed, but as the bags takes a bit longer to vacuum than the Eibos bags because of the smaller valve openings, during suction I release the seal for a couple of seconds at a time to let the pump get fresh air to cool down, again not sure if needed at all that's just what I do.
Best to Print with TPU 95A, no supports needed.
Dimensions (mm): 36.8 x 36.8 x 9.2
Used Filament(~): 6.8g