Bambu Lab X1 Poop Bucket Drawer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed a simpler way to get the waste filament out of the Original Design so added a Drawer
- Rating
- 5 / 5
- Likes
- 42
- Downloads
- 450
- Makes
- 3
- Views
- 2,312
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Firstly, Many thanks to Mikyleee for the Original Design ( https://www.printables.com/model/398786 )
I came across a few other remixed versions with an added drawer but most had made the angle of the waste slide to shallow and I wanted to keep the original angle.
When printing the drawer you need to change the Orca or Studio slicer to print the Z max height currently set to 250mm (standard) to 253mm this will allow the drawer to be printed front face down and you also need to either paint supports ( Tree Manual ) or set it to auto - your choice. The main Section of the Chute can be printed without support. The handle is printed face down and you can colour fill the lettering ( your Choice ) you will need a brass insert for an m3 bolt and short m3 x 8mm bolt .
IMPORTANT - Make sure you have no debris in the bottom of the printer - by which i mean in the recess's where the front 2x linear rod bearings disappear into - trust me when watching the drawer nearly finish printing you will think no way this is going to end good after such a long print - but it will.
Hope this helps.
ps One of the magnets is still on the back of the printer my gluing skills suck!
You also Need 6 off 6mm x 2mm Magnets for the main body.
Update
Added a Handle v2 file for anyone printing with a 0.2 Nozzle.