Arden Blobby Trays
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Share Alike
Some random blobby shaped shallow trays I modelled up in Onshape to try to make some use of some Fillamentum Timberfill I had around. There are two sizes, a larger one and four variations of a smaller one. They are handy for just throwing odds and ends into.
The larger tray is setup for multi-material printing and has four parts. They vary in height so a filament change is not sufficient to reproduce the effect, however you could of course keep it as one part and do filament changes if you just want stripes. For the smaller trays these are all once piece, the multi-material one shown in the pictures was just done with filament swaps.
For the trays shown in the pictures, the large one was printed in four different Timberfill filaments on a Prusa MK2.5S with MMU2S using a 0.6mm nozzle and 0.35mm layer height. The others on aa Prusa MK2.5S or MK3S also with a 0.6mm nozzle and 0.35mm layer height as well.
There are no rules though, print however you like, they are just random shapes after all. If you are going for the look in the photos keep in mind there is about 6 hours of sanding (160 through to 1200 grit) and then some linseed oil over the top.