Fly swatter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A fly swatter to mount on a steel rod. Reasonably tough if printed with a good filament.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 28
- Makes
- 0
- Views
- 383
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Wifey was tired of cheap flyswatter that were short and broke after a short time.
Made one to mount on a steel rod/tube that has a large area and has lasted a few years now.
Has started to tear at the tip but has survived much longer than any other flyswatter we have used until now.
Print without top and bottom layer, with a few perimeters and an infill pattern suitable to kill insects and remain hollow enough to reduce air resistance.
This one was printed with ninjatek armadillo, semiflexible while tough. Reguires glue to joint the parts.