Phillips SHP9500 headband fix for more side pressure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Reduces radius of the headband, allowing for higher side pressure. Now you can look down without headphones falling off
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 51
- Makes
- 1
- Views
- 446
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Public Domain
Got tired of my headphones falling down when i tilt my head forward, so i designed this small-ish fix for it. Basically, it reduces the radius of the headband a bit which allows for higher side pressure. With this fix you can look down and not be afraid of falling headphones and can even do some moderate* headbanging without loosing your headphones in the process
*some really good bangers will still send your headphones flying :)
Non-printed hardware:
- m3 x 10mm bolts, 2 to 5pcs (can be longer, but would look even uglier)
- m3 nuts, 2 to 5pcs
Settings/filament used:
- PETG (a bit more flexible than PLA, not sure if its matters much though)
- 0.3mm layer height
- 25% grid infill
- no supports
- no brim
- biggest flat side down
Print time on Sovol SV06 was about 2.5 hours