Phillips SHP9500 headband fix for more side pressure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduces radius of the headband, allowing for higher side pressure. Now you can look down without headphones falling off
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 51
- Wydruki
- 1
- Wyświetlenia
- 446
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Public Domain
Got tired of my headphones falling down when i tilt my head forward, so i designed this small-ish fix for it. Basically, it reduces the radius of the headband a bit which allows for higher side pressure. With this fix you can look down and not be afraid of falling headphones and can even do some moderate* headbanging without loosing your headphones in the process
*some really good bangers will still send your headphones flying :)
Non-printed hardware:
- m3 x 10mm bolts, 2 to 5pcs (can be longer, but would look even uglier)
- m3 nuts, 2 to 5pcs
Settings/filament used:
- PETG (a bit more flexible than PLA, not sure if its matters much though)
- 0.3mm layer height
- 25% grid infill
- no supports
- no brim
- biggest flat side down
Print time on Sovol SV06 was about 2.5 hours