WIPEINATOR-11000 Handi Wipe Holder

The WIPENATOR-11000 is a handy overhead holder for your Handi Wipes or other cleaning towels. Easy reach to clean your 3D print bed or any other area that can get messy.

Features:

• Saves space on counters or inside draws and takes advantage of unused space.
• Holes on the bottom give visual indicator that the dispenser is not empty
• Sturdy construction
• approx 11 CM of towels can be stacked.
• Print it with the PLA to match your cabinets.
• 4 screw mounts (I used 8x3/4"). Double stick tape could also be used.
• Fully assembled dimensions: L: 30mm: W: 18mm H: 12mm
• Inside dimensions (L: 28mm: W: 16mm H: 11mm) - Towel area

  Print Settings

Printer Brand:

Prusa

Printer:

No

Supports:

200

Infill:

Overture PLA

Notes:

• Print a single bottom piece. (I did not need supports on my MK3S. You may for the slots.)
• Print sides 2x. Lay them down so the logo is facing up. You should not need any supports in this position.
• Test fit. Sometimes your printer will make the slots on the side a bit messy. Clean them out with a small screw driver or thin file.
• File and sand to taste before assembly being careful not to over do it on the front facing parts.
• You can use the circles on the bottom to put your fingers through to get extra leverage for a tight fit.
• Once it dry fits nice, and a thin stream of super glue in the slots and quickly reassemble. Hold for 10-15 seconds

• Give any last minute sanding Mounting

• Use some tape to hold position your holder where you want it. Measure as you see fit.

• Mark the holes with a pencil
• Remove the unit.
• Drill a few small pilot holes. Careful not to go all the way through the cabinet.
• Screw in place by hand with a screw driver.

Category: Organization