Super Stong Honey Comb Wall 30mm

Honey Comb Wall 

I wanted a super sturdy honey comb wall (HCW) with very secure mounts.  This HCW can be screwed to a wall and panels can be epoxied together.  Built on 30mm hexagons.  Mods are screwed together and not press fit.  They are extremely strong.  

Wall Panels

Wall panels are 5 hexagons wide by 6 hexagons tall.  Walls are sized to fit on most print beds.  Min bed dimensions need to be 230x195.  There are 9 different panels in total.  4 corner panels and 5 middle/center panels.  Unlimited combinations can be made using these.  

Wall Mods

Mods for the wall are screwed together and are extremely secure.  The mod is installed from the front with a washer/screw from behind.  Very secure and cannot be pulled out.  Much stronger than being pressed into place.

Included mods

Needle Noes Pliers holder

Snips Holder

Scraper Holder (Ender) (Updated Design)

Glue Holder (glue stick, super glue and epoxy)

Glue Stick Holder

Large Glue Stick Holder

Storage Bin

Cleat (For mounting bins/holders)

Hook

Hanging clip (For hanging wall on side of Bambu X1)

Wall Mount (Mounting HCW to your wall)

Klein Screw Driver Mount

Attaching Mods to Wall

The mod is place into the wall from the front.  The washer and screw are from the back.  There are two screw types.  One is a slotted screw other is 5mm hex.  Either of the two can be used.  The hex is a little bit easier use, but they can be used interchangeably.

Slotted and hex tool included in STLs

Attaching HCW to your actual wall

Use the Wall Mount Mod to mount the HCW to your wall.  Sized for a drywall screw.  Place Wall Mount Mod through the front of the HCW.  Screw into stud or dry wall anchor.

Build Your Own Mods

Wall and Mod .STEP files are included.  Please feel free to edit and make cool shit.  My poorly dimensioned drawings are as follows. (Don't make fun of my shitty dimensioning)

The Wall

Mod Template

Threads are M16x2