Hours Till the New Year Counter
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.04 – €0.04 net (excluding VAT)
For file: washer_0.4n_0.2mm_PETG_MK4IS_55s.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.04 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 1.2 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A counter that mimics the New Year Ball Drop in New York City. This can be used to count the hours until the ball drops.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 19
- Makes
- 1
- Views
- 347
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Winter & Christmas & New Year's
- License
- Creative Commons — Public Domain
Important:
All parts are sliced with G-code ready for PETG printing. The pin is an optional print and can be used in place of a M3 x 16 screw. Do note the fitment of this part will be tight and it may needed to be sanded as it was meant for the screw to thread into the back of the ball.
Hardware:
2 - support legs
1 - main body
1 - ball
1 - M3x16 screw or optional pin
1 - Washer (printed part)
(optional glue) - can be used on support legs or on optional pin
Assembly Instructions:
If using the screw:
- Place the washer on the screw
- Place the washer and screw through the back of the main plate.
- Screw on the ball.
- Attached the supports at the bottom of the main plate
If using optional pin:
- Place the washer on the small side of the pin.
- Place the pin through the back of the main plate.
- Glue on the ball.
- You may need to sand down the end of the pin as the ball is designed for the threads to cut as the screw is screwed in.
- Attached the supports at the bottom of the main plate.
Information on printing:
0.2 mm layer height is recommended
Support on the ball is recommended only on the build plate.
15% Infill is recommended but others may be used.