1 / 2
REMIX Stackable Teabagbox (Vase-Mode, Taller, Bedadhesion, Rounded Bottom)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed the model of InstantBenHur. +1cm taller +integrated bed adhesion +rounded corners. ~50g filaments, <1h printing.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 38
- Makes
- 1
- Views
- 248
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of InstantBenHur. Many thanks for the awesome design & providing the .step file.
After I already printed three of the original models I noticed some possible improvements so I changed it to be
- Easier to stack (1cm taller)
- Faster and more reliable to print (rounded walls at the bottom)
- Easier to print (Mouse ear brim at the outer corners of the first layer)
Printing:
As InstantBenHur already described:
Switch to Vase mode.
Set the “Bottom Shell Thickness” to 4mm.
→ Since this was not possible after using Vase mode I did it the following way (see screenshot in the gallery above):
- Use variable layer height (so the rounded outer curves are printed nicely at ~0.28mm while the rest is printed at 0.36mm for my 0.6mm nozzle)
- Slice model
- Check at which layer the floor (on which the tea bags rest) is finished. For me this was at layer 11.
- Set Bottom Shell Thickness to 11 layers
- This will cause to the vase mode to start at layer 12.
- You can validate this by enabling seam visibility. The layers above the floor should not contain any seams.
This way I could print mine in 55min with ~50g of filaments.