1 / 7
Wham Bam Hotbox Foot and Extension Block — image 1
1 / 7

Wham Bam Hotbox Foot and Extension Block

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An extension block for the foot made by psdesign and posted to Thingiverse.

Rating
0 / 5
Likes
0
Downloads
11
Makes
0
Views
98
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

I did not make the foot file included with my upload. That was made by psdesign and posted to Thingiverse at this link. I made the 50mm extension block. 

I bought the Wham Bam Hotbox Mega for my Ender 3 Max. I was pretty sure it would be too short because I have a dual Z upgrade with a handwheel on the second Z screw. I printed the feet before the hotbox arrived. After blocking the enclosed up with some books I determined I need to raise it 45mm at least.

I have not printed anything yet. I am concerned that the air gap will allow too much heat to escape. If it does I'll figure out a curtain or cardboard extension to close off the airgap.

The final design was printed upright without supports or rafts. I took psdesign's advice and used these rubber feet on Amazon for a nonslip bottom. With the pad, the block is about 55mm tall.

Tags