Wham Bam Hotbox Foot and Extension Block
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An extension block for the foot made by psdesign and posted to Thingiverse.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I did not make the foot file included with my upload. That was made by psdesign and posted to Thingiverse at this link. I made the 50mm extension block.
I bought the Wham Bam Hotbox Mega for my Ender 3 Max. I was pretty sure it would be too short because I have a dual Z upgrade with a handwheel on the second Z screw. I printed the feet before the hotbox arrived. After blocking the enclosed up with some books I determined I need to raise it 45mm at least.
I have not printed anything yet. I am concerned that the air gap will allow too much heat to escape. If it does I'll figure out a curtain or cardboard extension to close off the airgap.
The final design was printed upright without supports or rafts. I took psdesign's advice and used these rubber feet on Amazon for a nonslip bottom. With the pad, the block is about 55mm tall.