Trustfire TR-J18 flashlight stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This flashlight stand is based on my Trustfire 3T6 flashlight stand (http://www.thingiverse.com/thing:618322). I have…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 175
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
NOTE: Imported from Thingiverse without updates…
This flashlight stand is based on my Trustfire 3T6 flashlight stand (http://www.thingiverse.com/thing:618322). I have updated the OpenSCAD file to calculate the stand thickness so I recommend this as your starting part for any derivative designs. There are plenty of "Knock-off" makers so please verify the dimensions match your flashlight: 33.5mm on switch end, 33.5 on LED end, 63mm head head diameter, and 160mm for center-to-center of supports. If you need an additional size and are not familiar with OpenSCAD let me know and I can create & upload. I have included a picture that shows all three of my flashlights and stands.
Instructions
My settings are below but any setup should work OK.
0.3mm layer height
low density fill (10%)
thick (3) shells
Category: Electronics