Plaid tie - FULL size
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Elegant FULL sized plaid tie model (about 40cm long). 3D printable fabric used. Heatbed at least 300 x 300 mm required.
- Rating
- 0 / 5
- Likes
- 59
- Downloads
- 218
- Makes
- 0
- Views
- 1,179
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Men
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is FULL sized model of elegant plaid tie made using my 3D printable fabric (cca 40cm long).
You may already know my earlier model (https://www.printables.com/model/559504-plaid-tie), which could be printed on the classic Prusa MK3S+ (and the smaller size even on the Prusa MINI). But these ties might be too short for some.
So I decided to make a longer FULL sized version, which I believe could be the classic tie length. I can't print this tie because I don't have a printer with 300x300mm bed, but I estimate that the length of this tie in the hanging state will be about 40cm.
Note the different pointy “knot” design, where is a hole to tie it around the neck. I used stretchy string about 60cm long. After tying you can hide the string under the collar.
Printing:
There are no special printing requirements, NO supports. Heatbed at least 300 x 300 mm required.
Printig tips:
- Use concentric infill for the top layer.
- Use textured plate. The tie will look nice from the other side as well.
- To make even smaller size use only XY scale in the slicer.
- To make larger size I would use XYZ scaling in the slicer.
Also check out:
https://www.youtube.com/channel/UChKp-968z1i5PN29gbR7YfA
https://www.cgtrader.com/rorys3d