ZSA Voyager ultimate tenting bar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The ZSA Voyager keyboard original printable remade: Pick any lateral and forward tilt angle.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 181
- Makes
- 1
- Views
- 2,722
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
Inspired by the original tenting bar published by ZSA and using the STL they published, I created an OpenSCAD model that's fully customizable.
Parameters that can be adjusted:
- lateral tilt angle
- forward tilt angle
- magnet diameter and depth
- screw diameter
I'm uploading models for many angles that made sense, but I haven't tested all of them. My current favorite picks are the 10 degree tenting and the 10 degree tenting with 5 degree forward tilt.
Use mirror in the slicer to get the tenting bar for the other side of the keyboard.
All models consider a 10mm diameter magnet that's 3mm thick and using 3mm-diameter screws with conical heads. You can find these magnets on Amazon.
Photos shown are of the 10 degree version.
At aggressive tilt or when using a forward angle, an outside support is also needed for stability. Add some anti-slip pads for using on a regular desk. I have been using them on a mousepad-like desk mat just as printed without issues, though. For full comfort, a wrist rest is needed. Hopefully I'll make one soon.
These are the magnets I used: https://www.amazon.com/dp/B09ZLFNZ4S?ref=ppx_pop_mob_ap_share
Didn't use the 6mm magnets like the ones ZSA uses because I couldn't find some on Amazon and the 3 mm do the job fine.