ZSA Voyager ultimate tenting bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The ZSA Voyager keyboard original printable remade: Pick any lateral and forward tilt angle.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 181
- Wydruki
- 1
- Wyświetlenia
- 2722
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Inspired by the original tenting bar published by ZSA and using the STL they published, I created an OpenSCAD model that's fully customizable.
Parameters that can be adjusted:
- lateral tilt angle
- forward tilt angle
- magnet diameter and depth
- screw diameter
I'm uploading models for many angles that made sense, but I haven't tested all of them. My current favorite picks are the 10 degree tenting and the 10 degree tenting with 5 degree forward tilt.
Use mirror in the slicer to get the tenting bar for the other side of the keyboard.
All models consider a 10mm diameter magnet that's 3mm thick and using 3mm-diameter screws with conical heads. You can find these magnets on Amazon.
Photos shown are of the 10 degree version.
At aggressive tilt or when using a forward angle, an outside support is also needed for stability. Add some anti-slip pads for using on a regular desk. I have been using them on a mousepad-like desk mat just as printed without issues, though. For full comfort, a wrist rest is needed. Hopefully I'll make one soon.
These are the magnets I used: https://www.amazon.com/dp/B09ZLFNZ4S?ref=ppx_pop_mob_ap_share
Didn't use the 6mm magnets like the ones ZSA uses because I couldn't find some on Amazon and the 3 mm do the job fine.