1 / 5
5KG Bearing Spool Holder with Brake — image 1
1 / 5

5KG Bearing Spool Holder with Brake

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Preliminary estimate for PETG

€2.45 – €2.99 net (excluding VAT)

For file: BearingRod-Roller_0.4n_0.2mm_PETG_MINIIS_2h10m.bgcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €2.72 excluding VAT (range midpoint).

Weight reported by the author
49 g
Print time reported by the author
2.16 hr
Source material
PET
Estimate material
PETG
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

Remix of the "pipe bearing" for the 5KG Bearing Spool Holder designed with a brake.

Rating
0 / 5
Likes
4
Downloads
39
Makes
0
Views
638
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

The 5K Bearing Spool Holder seemed like the quickest solution that fit my environment.  However, the spool was free to spin and quickly created a tangled mess.  

I looked for any solution that would address ‘the spin’ but couldn't find anything that interested me.  I wanted something simple and reliable.

I tried using just a wooden dowel but it falsely triggered my filament sensor. There must have been too much drag.

And then I found working a piece of rubber band between the rod and bearing created enough resistance to solve the problem… at least until the band worked itself out.

Solution

By just putting a hole in the rod ends it became possible to place a TPU washer between the bearing and rod and tighten it to create a clutch.

It worked! I could tighten the screws until the bearings didn't move, or loosen it until the spool was free to spin. It is super easy to adjust. 

Hardware

To keep the profile as low as possible I used flat-head screws. The holes are for 3mm screws.  You need a washer to make up the difference between the screw head and bearing edge.

Assembly

Using 3mm Flat-head screws and a steel washer on the outside, secure the TPU washer between the roller and the bearing and tighten the 3mm screw until there is adequate resistance. Repeat on the other side of the pipe bearing.

Tags