Philips Sonicare Electric Toothbrush Holder (3M Command Strip Wall Mount)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3M Command strip mounted Philips Sonicare electric toothbrush holder. Designed with replaceable retaining clip and base.
- Rating
- 4.8 / 5
- Likes
- 108
- Downloads
- 605
- Makes
- 6
- Views
- 3,089
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Overview
This Philips Sonicare toothbrush holder is designed to allow toothbrush insertion from the top or side. This holder allows toothbrushes to be more easily stored higher on walls, far out of reach from splashing sink water, etc.
The holder should be mounted on a vertical surface using one large 3M Command strip (strip size approx. 0.75"x2.75"). This model is split into three printable parts to minimize need for supports* and to enable easy replacement of parts in contact with the toothbrush if they become dirty over time without removing the command strip. The printed parts are connected using dovetail joints and compliant retaining clips that can be depressed using a fingertip.
Slicing/Printing
These models should be sliced in the orientation shown in the slicer image included in the post. They have been tested with 25% “grid-pattern” infill, and “snug” supports enabled in PrusaSlicer 2.7.1. Layer height has been tested with 0.1mm and 0.15mm. Models have been chamfered on the recommended print faces to help reduce any elephant foot issues when printing.
These models have been printed successfully using Prusament PLA.
After printing, be sure to remove the small amount of support material from under the two compliant retaining clips on the toothbrush_wallplate and from under the dovetail groove of the toothbrush_neckclip.
Assembly
After preparing the three components, the toothbrush_neckclip and toothbrush_baseplate can be slotted into their respective dovetail grooves on the toothbrush_wallplate. Note that the grooves for the toothbrush_neckclip and toothbrush_baseplate are different shapes.
In addition, note that the toothbrush_neckclip should be oriented so that it is centered left-to-right on the toothbrush_wallplate when fully inserted. If it is not centered, remove it and insert it the other way.
Mounting
The model is mounted using a large 3M Command Strip (strip size approx. 0.75"x2.75"). Two small right angle ‘L’ slots have been incorporated into the toothbrush_wallplate to help align a Command strip in the center of the print. This has been successfully mounted to a bathroom mirror.
*Supports should be enabled to ensure the compliant retaining clips on the toothbrush_wallplate and the dovetail on toothbrush_neckclip print with correct final dimensions.