FLSUN V400 Build Plate Guide/Indexer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Guide for quickly aligning your build plate.
- Rating
- 4.875 / 5
- Likes
- 57
- Downloads
- 536
- Makes
- 8
- Views
- 1,461
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Guide for aligning (indexing) your v400's build plate.
I printed mine with the following settings:
- 3 Perimeters
- 3 Bottom Layers
- 0 Top Layers (top side of print is hidden once attached)
- 20% Gyroid Infill
- No supports
Installing:
Attaches to the rear pillar, upside down from the print orientation.
Slot the right side in first, before pressing in the left side. It should click into place, and you can then slide it down to the bottom of the pillar.
Depending on your tuning, it may be a tight fit, if so then you may insert the clips at an angle, and then twist the part in.
If the print touches the magnetic sheet:
The guide should not be resting on the magnetic sheet. Some of the magnetic sheets on v400s are slightly off center, so if you print the base model, and find that it is hitting the magnetic sheet, then you can print one of the adjusted models (+2mm, +1mm, -1mm, -2mm). The positive offsets will push the guide away from you, while the negatives will move it closer.
Was made to mesh well with my inner pillar covers:
https://www.printables.com/model/715693-flsun-v400-pillar-inner-cover
Download the ‘(Shortened)’ file, as the full size will not fit with the indexer installed.