Küpper Pegboard Hook (short and firm)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.59 – €0.72 net (excluding VAT)
For file: kupper_hook remix_0.3mm_PETG_MK3S_44m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.66 excluding VAT (range midpoint).
- Weight reported by the author
- 7 g
- Print time reported by the author
- 44.4 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a remix of the Kupper peck board hook which is slightly shorter and thicker than the original design.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 180
- Makes
- 0
- Views
- 692
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
For an optimal print result, consider adjusting the following settings in your slicer:
- Orient the model, so that the hook part points upwards.
- Use supports, but on build plate only.
- Make sure that the “Top contact Z distance” is large enough (e.g. 0.3 mm), so that the supports can be easily removed.
- Think about using more perimeters and a higher infill density for the hook part.
- The overhang on the hook itself is 45° and should print fine without supports.
If you have access to an MK3S+, feel free to use my gcode. I had great results using PETG.