Asthma Spacer Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounting clip for an asthma spacer, modifiable step files included.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 26
- Makes
- 1
- Views
- 219
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- GNU General Public License v2.0
Asthma spacers are bulky and tend to roll around. These clips hold the spacer firmly to any surface (even under shelves and desks!). You can get away with printing only one if mounting to the wall, though if you want it to be mounted under a desk, using two is required.
No supports or adhesion needed, however the must be printed laying on their sides. If you print them on their backs with the prongs going upwards they will snap off in use.
20% infill with PLA provides a good level of spring and durability. For the screw on model, be careful to not accidentally crack it (the PLA stands no chance against a good drill). The thread part of the screw hole has a 4.8mm diameter, with a head diameter of 8mm fitting most wall screws. For the glue version, fully cured no more nails is effective at holding it in place when correctly aligned.
When aligning, its a good idea to clip the spacer on and use that as a guide as to where to place the clips, if they are misaligned no more nails can fail (well, in my case the paint of the wall failed) and it can cause difficulties in removing the spacer even without a failure.