1 / 2
Voron V0.2 - Tophat 1515 sealing block — image 1
1 / 2

Voron V0.2 - Tophat 1515 sealing block

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Block with adhesive foam stripe to seal the tophat of your Voron 0.2!

Rating
5 / 5
Likes
58
Downloads
219
Makes
4
Views
1,239
Reviews
4

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

During my attempts to increase the chamber temperature, i noticed that there were small gaps all over the tophat, allowing warm air to escape.

To reduce this I have designed a small block onto which 8mm wide self-adhesive foam strips can be glued. The block is slightly beveled, which makes it easier to close the tophat and also provides a good sealing.

There are 2 versions : 

  • Large one (single one to print for each side)
    • Use 4x M3x8mm screws to fix it in place
  • Small one (print 2x parts for each side - printable on V0 itself!)
    • Use 8x M3x8mm screws to fix it in place

For reference - these are the foam stripes I used. 8mm wide and ~1mm thick (leftover from Formbot kit), just glue them into the groove on the side : 

 

Tags