1 / 1
Vibration Dampening mount for PSU of E3D ToolChanger — image 1

Vibration Dampening mount for PSU of E3D ToolChanger

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A vibration dampening mount for the PSU of the E3D ToolChanger

Rating
0 / 5
Likes
1
Downloads
13
Makes
0
Views
94
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

When printer my ToolChanger made a lot of noise. It turned out to be coming from the PSU (see video.) I made this vibration dampening mounts for the PSU to make it silent again.
 

I printed the dampener parts (A & B) with NinjaFlex, 0.2 mm layer height, 3 wall lines, 3 bottom and top layers and 100% infill. The Nut holders I printed with PLA.

Installing:

  • Lie the ToolChanger on it's front (mind the tools when doing this, when they are too heavy they will fall down)
  • Unscrew the PSU
  • Place Dampener Part B (orange) inside Dampener Part A (Red)



     
  • Screw the dampeners (without the washers) to the PSU using the screws it was mounted with to the TC
  • Put the M3 nuts in the Nut Holders and put those inside the dampeners, try to center them as much as possible
  • Use the M4 washers and M3x12 screws to mount the dampeners to the TC (this step can be quite annoying, some cursing might be needed ;-))

Prints:

  • 4x Dampener Part A
  • 4x Dampener Part B
  • 4x Nut Holder

Needed hardware:

  • 4x m3x12 Screws
  • 4x m3 Nuts

 

 

Tags