LayersFactory
Report model
1 / 5
SOTABeams Power Conditioner Case — image 1
1 / 5

SOTABeams Power Conditioner Case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

Source
Printables
Category
Electronics
License
Creative Commons — Attribution
DetailsMakes & commentsRemixesCollectionsRelated

A printable case for the SOTABeams Power Conditioner Kit

This kit converts 7-20 VDC into very clean 5.1 VDC (@200 mA) for use in powering USB radio devices like the WSPRLite.

Additionally required for assembly:

  • 6x M2x4 screws

  • 6x M2x12 standoffs
    (An additional M2 standoff can make screwing in the standoffs a bit easier)
    It should be possible to use M3 hardware instead, but driling out / tapping the screw cylinders would probably be necessary.

    The back is ventilated to provide some airflow over the heatsink on the back of the circuit board.

    When constructing the kit, the LED should be stood off the board as much as possible to line up with the hole in the case.

Print instructions

Licence: Creative Commons - Attribution Category: Electronics Print Settings

Printer Brand: FlashForge

Printer: Creator Pro

Rafts: No

Supports: No

Infill: 40%

Notes:

Printed in translucent PETG. Just about any filament will do - this is an uncomplicated print.

Tags

powersupplythingiverseamateurradiopowerpolepowerconditionersotabeamswsprwsprlite