Simple Case for TubeHobby NCV2.1 Nixie Clock

This is a simple but elegant case for the TubeHobby NCV2.1-14 Nixie Tube Clock.

There are a couple of advantages of this case as compared to the one I made previously:

• It is easier/simpler to fit the clock into the case, due to a new design that uses side rails to slot the circuit boards into for a perfect fit
• The overall case design is sleeker, since the top is not a separate piece - it looks like a single piece from the front
• Optimized to put facing surfaces (front & top) down when printing, keeping all rougher surfaces on the interior of the case
• Access to rear controls/ports is better
  The back is a press-fit, and slots into the same grooves as the circuit boards. The idea is to later modifiy the back for shrouds over the tubes, etc.

Print instructions

Licence: Creative Commons - Attribution Category: Electronics Print Settings

Printer Brand: FlashForge

Printer: Creator Pro

Rafts: No

Supports: No

Infill: 50%

Notes:

Printed in PETG - ABS is not advised due to warping.

How I Designed This

Designed in Fusion360 - if you'd like me to share the project, please just let me know.