A Beefier Banggood Power Supply Case

There are many different cases for various versions of Banggood power supplies out there, but I didn't find one that really fit what I wanted for one of the largest - the DPS5015 (50V 5A).

I didn't need the high current, nor the top end of the voltage range, so I found a 48V @ 2A power brick on eBay, and used that as power. Input is a standard 5mm barrel connector, and the output is chassis mount banana plugs.

There is also the provision for a 40mm chassis mounted fan in the back.

Required to assemble and make into a working power supply.

1) Input power supply up to 55V @ 15A. (I used 48V @ 2A)
2) 4x M3 plastic screws for attaching board to chassis
3) Chassis-mount banana plugs
4) Wire connections to input and output power with included spade plugs
5) 4x Self-tapping machine screws to attach top

Optional:

6) 40mm fan
7) 4x M3 screws for attaching fan to case

Print instructions

Unassociated tags: power supply

Licence: Creative Commons - Attribution Category: Electronics Print Settings

Rafts: No

Supports: No

Infill: 40%

Notes:

Printed in PETG. Would be difficult to print with ABS due to warping, but perhaps possible.

How I Designed This

Designed using Fusion360