1 / 12
Handy Hand Holder for desk and wall- Voronoi — image 1
1 / 12

Handy Hand Holder for desk and wall- Voronoi

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a multi-use hand that can hold Jewlery, sports balls, and more! Please read the assembly guide bellow! have fun!

Rating
0 / 5
Likes
41
Downloads
155
Makes
0
Views
966
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is a universal mount for anything you want to display on the wall! it could be your favorite jewelry, tool, shoes, or sports ball! It's also a perfect gift for one of your sporting friends!

I originally designed in blender to hold a soccer ball I got from my Under Fifteens 2023 grand finals. I wanted an extra cool stand to display it on, and one of my teammates said it should be a hand. It was pretty difficult as I have never really done anything like this before so most of it was learnt along the way. 

The hand looked a bit too bland for my taste and lacked the artistic look to it. I then stumbled upon the Prusa challenge for Voronoi which I thought would be perfect for this design! I reworked the hand to be useable and strong enough to display a sports ball! 

Now enough of the Back story, let's get into how you should print it!

IMPORTANT: the maximum safe weight load is no more than 2kg (untested). Please don't go anything over, as the hand might break!

  1. Hand orientation

The hand has to be sliced in a specific way for the best strength, and minimal overhangs. The angle its rotated from the flat base is 30 degrees. So please orient the hand like this: 

This way the Voronoi pattern can print without many overhangs and look good too! you will have to use supports on the bottom, but it's a lot less supports than having to print it flat! The support brim is 20mm for best adhesion. The infill is 30% while the wall line count is 4. Please DONT cut up the model if it's too big, as the strength will be drastically reduced. You can scale it down if necessary but print the same way. 

 

2. structural pieces

I suggest printing the block on the long side like this, so it has the required strength! The infill is 30% and the wall line count is 4.  

3.  wall mount

Everyone gets creative! I have uploaded a blank wall mount so you can add your own patterns and textures that suit your need! you can print the whole thing or design your own wall back by just adding the Wall_mount to it! 

Or you can be like me and make the back from a material like wood for the desired artistic look! The base dimensions are 185mm x 140mm with the depth no less than 5mm (for strength purposes). 

If you want to print the base, print it flat with the infill at 20% and wall line count at 3. top and bottom surfaces is 3-4.

 

4. Table Mount

If you print the table mount, then you can print the whole one, or them separated. The NOHOLE one is for you to remix a bottom stand and add it on later. It won't fit the premade stand, only the normal one will. use the same hand, and support block.

5. assembly

The assembly is pretty straight forward, as the Support_block goes into the holes in the hand and base. you can then mount the whole thing to your wall using the little Velcro stick things, or some nails/screws. 

The tabletop version is pretty much the same, you just might need to glue on the mount block, or print the whole one, then inserting the Support_block in the holes in both the hand and base. 

If you print the table version, then you can print the whole one, or the split one. You can remix both the bases as you see fit and upload them as a make!

Thanks for this inspiring challenge Prusa! I was able to grow in my skills and make something Awesome!

Tags