Sagemcom DIW7022 (2024 KPN decoder Set-Top box) wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€7.29 – €8.92 net (excluding VAT)
For file: Sagemcom_DIW7022_mount_0.6n_0.32mm_PETG_MK4_4h36m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €8.10 excluding VAT (range midpoint).
- Weight reported by the author
- 187 g
- Print time reported by the author
- 4.6 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Sagemcom DIW7022 (The 2024 KPN set-top box, decoder, itv interactieve tv) wall mount, So it's nicely hidden away.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 59
- Makes
- 0
- Views
- 553
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A wall mount for the Sagemcom DIW7022 set-top box, known as the current (2024) set-top box of a Dutch internet/tv provider knowing: KPN.
Holes for the screws are 3mm in diameter, with a 4mm diameter drop to hide to top of the screws.
The wall-side is made pretty beefy (18mm thick), but this fits my personal setup with the screws i had.
I've added a slotted vent pattern, to give it some air.
The set-top box should fit somewhat snuggly.
The backside should give space to fit each connector, if that is not the case, let me know ASAP, then i will edit the model. (I did not print this version myself, i'm gonna re-use my older KPN decoder mount, which this is based on)
Havn't printed this variant of the decoder wall-mount, but i've made sure it would fit according to physical size, I'm re-using the photo of the original 2021 model that i've made , hence why the photo is blurry.
Recommanded print settings:
- 0.6mm nozzle
- 4 perimeters (This makes the screw holes strong)
- 3 top and 3 bottom solid layers
- 20% gyroid infill
- 0.32mm or 0.40mm layer height (since this is a structural design, no need to make it nice)
- Supports OFF
- Every other setting is the stock Prusament PETG setting in 0.6mm nozzle config
Printing orientation: standing up on the backside. (with the side where the connecters would go to the printbed)