1 / 2
IKEA Ivar board no wooden parts for 50cm depht
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
You are bored of the normal IKEA shelf boards? With this model you can make your owns with your own length....
- Rating
- 5 / 5
- Likes
- 79
- Downloads
- 253
- Makes
- 5
- Views
- 1,737
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
With this model you can make some shelfboards which are compatible with an Ikea Ivar shelf. I made these because I have a door between two Ivar shelfs and I wanted to use also the space over the door, and because there was no Ikea shelfboard with the exact lenght I made my one. So if you have similar problems this might be the solution. Please follow the short Instruction below.
Instruction
- Attention this is for the 50 cm depth version of IKEA Ivar, here is the version for the 30cm deep one
- Print the model four times, I changed the wall and the botton/top thickness so it's even more stable and printed it in PLA. (2x right, 2x left)
- Cut a board which is 18mm thick, 50cm deep and how long as you need it.
- screw the four parts with a distance of 3,5cm to the edge, best you start with the screw in the middle, then the two outer screws.
- Now you can just insert the shelf board like the normal IKEA Ivar shelf boards.
hope you like the model, give me your feedback in the comments.
best regards
mlax