1 / 2
IKEA Ivar board no wooden parts for 50cm depht
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You are bored of the normal IKEA shelf boards? With this model you can make your owns with your own length....
- Ocena
- 5 / 5
- Polubienia
- 79
- Pobrania
- 253
- Wydruki
- 5
- Wyświetlenia
- 1737
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 5) (Komentarze: 11)Remiksy (0)Kolekcje (125)Powiązane
With this model you can make some shelfboards which are compatible with an Ikea Ivar shelf. I made these because I have a door between two Ivar shelfs and I wanted to use also the space over the door, and because there was no Ikea shelfboard with the exact lenght I made my one. So if you have similar problems this might be the solution. Please follow the short Instruction below.
Instruction
- Attention this is for the 50 cm depth version of IKEA Ivar, here is the version for the 30cm deep one
- Print the model four times, I changed the wall and the botton/top thickness so it's even more stable and printed it in PLA. (2x right, 2x left)
- Cut a board which is 18mm thick, 50cm deep and how long as you need it.
- screw the four parts with a distance of 3,5cm to the edge, best you start with the screw in the middle, then the two outer screws.
- Now you can just insert the shelf board like the normal IKEA Ivar shelf boards.
hope you like the model, give me your feedback in the comments.
best regards
mlax