1 / 4
Sunlu S2 - PTFE connector
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I just remixed one of the models, because pretty much every single one I see, uses the PC4-M10 and I had a couple of M6.
- Rating
- 5 / 5
- Likes
- 55
- Downloads
- 305
- Makes
- 4
- Views
- 2,259
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I used Permanent glue to get it in place and a little piece of PTFE in the interior, to make it easier when passing the filament.
If it was useful for your setup, please consider leaving a like.
