GPS mount for Canyon Grail (hoverbar)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Out-front GPS mount for Canyon Grail, mounting to the top of the hoverbar. Compatible with Garmin or Wahoo devices
- Rating
- 4.5 / 5
- Likes
- 13
- Downloads
- 185
- Makes
- 1
- Views
- 2,317
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I found the GPS mounting point on the Canyon Grail's Hoverbar too low to reach while riding, so I designed this mount for the “flex zone” of the upper bar.
*** New version for Garmin quarter-turn mount, 30 mm wide: thicker to make it more robust and less prone to snap when riding offroad, changed mounting design (hidden mounting screw with captive nut instead of threaded insert) ***
Fusion 360 file uploaded
Also available in three older versions:
- For Garmin quarter-turn mounts, 20 mm wide or 30 mm wide
- For Wahoo quarter-turn mounts, 30 mm wide
Required hardware:
- Garmin or Wahoo Quarterturn mount
- 2x screws M3 x 8
- 1x screw M3 x 16
- for older versions: 1x M3 threaded insert (M3 x 5 x 4)
- for version 6: M3 locknut (4mm high)
- some frame protection tape (protects bar from scratches and improves fit)
Print parameters:
- ASA (or ABS) filament
- >5 perimeters
- 80% infill
- 0.4 mm nozzle
- 0.2 mm layer height
Print the part on its side and use brim if necessary.