1 / 5
Aquarium - Water Outflow to hide water outflow tubing going to filter system — image 1
1 / 5

Aquarium - Water Outflow to hide water outflow tubing going to filter system

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Aquarium quarter pie segmented (max 75cm height) covering to hide water outflow pipe leading to external filter system.

Rating
0 / 5
Likes
33
Downloads
78
Makes
1
Views
1,575
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial — Share Alike

This design created using Fusion360 forms a quarter pie column (75cm in height) made up of 4 segments that hides the tubing for water out flow to an external cannister filter system.  It also provides a way to run a hidden air tube from the top down into the base of the tank.

Slits (2mm wide) in the top of the column (section 4) and the bottom (Section 1) allow for easy water movement into the column.  Section 1 water flow slit has covers to ensure slow moving fish do not get suctioned up against the wall.

 

Model Assembly

Step 1 - run air line through hole in base and attach suction cups.  Place base in corner of tank in vicinity of water outflow tube and ensure it is secure to the base of the tank (optionally if the tank is currently dry you can use silicon to seal it to the base instead of suction cups).

Step 2 - attach section 1 to section 2 and then thread small filament piece of 1.75mm filament through connectors to keep segments connected.  This process can be repeated with section 4 to be used for the last top section.  For section 4 apply suction cups to suction cup holders (unless the tank is dry and you plan on using silicon t seal the column to the tank walls.  Also place two plastic screws (section 4 screw) into the bottom of the screw holes at the top of section 4 and rotate in a few turns so they do not fall out.

Step 3 - place segment column into aquarium with base of section 1 set into the secured base and quarter pie pushed up to the perpendicular aquarium walls.  Press section 4 suction cups to wall to secure.

Step 4 - tighten the screws in section 4 until the press against the base of the aquarium rim to help hold the column in place.

 

Maintenance

Once assembled rinse in water before implementing into aquarium.  Once in use it can be cleaned with a toothbrush as part of general tank maintenance.

 

Print Tips 

Printed on a MK2.5s using black PETG that mimics the tank walls so that it disappears into the background when correctly lit.

For aquariums less than 75cm in height print only section 1, 2 and 4.  You may need to stretch or shorten section 2 to meet your tank needs depending on the height of the tank.

Tags