1 / 4
FlySky FS-I6X FPV Screen Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed to hold Eachine EV800D, but since the interface of M6 is common, you can also you this with other products.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 88
- Makes
- 1
- Views
- 614
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
You will need these components:
M3x30 Screw *2
M3 Nut *2
M6x12 Bolt *1
M6 Nut *1
Setup: Insert the M6 nut to the slot and tighten the M6 bolt. Then insert the joint to the rod of the frame. then insert the joint part 2 and insert M3 screws and nuts. Tighten enough to hold FPV screen rigidly.
Frame can be installed to the I6X without any glues. Just use 2 tie wraps. You can find the locations on the photos.