Signage Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My partner needed these to hold signage at the school. The ones I was modeling after were fragile and mostly destroyed.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 26
- Makes
- 0
- Views
- 104
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed mine at .28mm. I printed with both my .4 and .8 nozzles and they printed about the same grip on paper. the .4 was a bit stronger…I think.
In the photos you can see the 2 new designs (sloped sides and 2 top layers. The right is the old design. No slope and only 1 top layer.
The model has the teeth overlapping. This is because when you slice them you will get a slight gap. If I design it with the gap, it prints much larger. This is due to print resolution.
I included step, f3d, and 3mf files.
.28 mm (on .4 or .8 nozzle)
No supports
No rafts
No brim needed
1 bottom layer
2 top layers
15% infill (grid)