GPS & VTx antenna TPU for AOS UL7
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tail TPU unit to hold a Matek GNSS/Compass M10Q-5883 and SMA bulkhead for a VTx antenna.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 35
- Makes
- 0
- Views
- 329
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This two piece TPU print holds a Matek M10Q-5883 GNSS (GPS)/Magnetometer (Compass) and a SMA antenna bulkhead for a single VTx antenna for a AOS UL7 FPV drone.
Both pieces are printed without supports using eSUN 1.75mm TPU 95A Flexible 3D Printer Filament. The AOS_UL7-GPS_TPU.3mf file includes the pause command for inserting the plastic nuts.
Plastic bolts and nuts used to minimize interference with the GNSS/Compass unit.
Material used:
- IPEX or U.FL to SMA or RP-SMA Female Bulkhead Mount. Verify the appropriate connectors for your antenna and VTx unit; example IPEX to RP-SMA Female Bulkhead Mount RG178.
- 2 x M3 20mm plastic bolts eg. M3 Nylon Hex Spacer Standoff Kit.
- Matek M10Q-5883
- eSUN 1.75mm TPU 95A Flexible 3D Printer Filament
NOTE: Never power-up the VTx unit without the antenna attached to the SMA bulkhead otherwise it's very likely to damage the VTx.
Enjoy!