Vase mode Mushroom Shelf
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mushroom printed in vase mode and held by an internal support.
- Rating
- 5 / 5
- Likes
- 250
- Downloads
- 610
- Makes
- 4
- Views
- 3,569
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Printing the mushroom:
I printed with a layer height of 0.16 in vase mode.
On the bottom of the print there is a 0.6 mm deep rectangle valley so for example in Cura slicer if you uncheck the “Remove All Holes” setting and set the number of bottom layer to 3 then the mushroom vase will have the rectangular hole you need. After finishing the bottom layers it will continue with the vase mode as normal.
Printing the support:
I printed with 0.2 layer height, no support. NOT in vase mode.
Assembly:
Two screws in the wall to hold the support. Then as you insert the mushroom you should be able to push it down a bit so the bottom layer of the mushroom will get in-between the wall and the support piece.
