Vase mode Mushroom Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mushroom printed in vase mode and held by an internal support.
- Ocena
- 5 / 5
- Polubienia
- 250
- Pobrania
- 610
- Wydruki
- 4
- Wyświetlenia
- 3569
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Printing the mushroom:
I printed with a layer height of 0.16 in vase mode.
On the bottom of the print there is a 0.6 mm deep rectangle valley so for example in Cura slicer if you uncheck the “Remove All Holes” setting and set the number of bottom layer to 3 then the mushroom vase will have the rectangular hole you need. After finishing the bottom layers it will continue with the vase mode as normal.
Printing the support:
I printed with 0.2 layer height, no support. NOT in vase mode.
Assembly:
Two screws in the wall to hold the support. Then as you insert the mushroom you should be able to push it down a bit so the bottom layer of the mushroom will get in-between the wall and the support piece.
