Small trowel for plaster lists
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.39 – €2.92 net (excluding VAT)
For file: ATTENTION 240 degrees trowel.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.66 excluding VAT (range midpoint).
- Weight reported by the author
- 54 g
- Print time reported by the author
- 1.66 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Trowel for plaster lists in tight spaces.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
I have created a small trowel designed to ensure a precise distance between the bottom of the tile and the surface of the plaster (eg https://www.pinterest.it/pin/21532904457891450/). This tool ensures a uniform and leveled plaster surface, without deformations or depressions, creating the 'plaster lists' and allowing for an accurate laying of tile adhesive.
What to print
Print the trowel and one of the 'pressors' according to the necessary dimensions.
Use an M8 nut and bolt, or print them from the same '3mf' file.
Recommended: glue the nut to the trowel in the designated seat.
The images should clearly illustrate their use. If not, feel free to ask for clarification.
During your DIY projects, select the appropriate thickness based on the toothed trowel (6mm, 8mm, 10mm) and the thickness of the tiles you plan to use.
Printing recommendations
The trowel requires 4 hours of printing with a 0.4 nozzle, but you can use the other file "rapid.3mf" to take inspiration from the settings I use for my personal prints. In summary, I increase the extrusion width, the infill printing speed, and I raise the nozzle temperature to 240°C when the volumetric flow rate exceeds 8-10 mm^3/s. Therefore, pay attention and always check the printer. This way, the print will last less than 2 hours.