Itty Bitty Fidget 8x1,25 magnet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
"A super tiny sliding fidget that uses less than 1.5m of filament" and you can use with 8x1,25 magnets 😃
- Rating
- 4 / 5
- Likes
- 8
- Downloads
- 39
- Makes
- 1
- Views
- 280
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
I'll display below the original instructions of 3DPrinty
Printing
This model is very small and requires accurately printed clearances to work as expected.
Print slowly and avoid brittle or inconsistent filaments.
Assembly
Press fit the magnets into the button and bottom case first. Make sure magnets are oriented to pull the button toward the bottom case. If the magnets are loose, glue them in.
The top and bottom pieces snap together. These snaps are very tight, so they may require some force to work.
Gluing the case shut is not recommended. If you do glue the case together, limit the glue to only the ends of the case. This is particularly important if you're printing the no-magnet version, as the case needs to flex slightly at the middle.
Can I sell copies of this?
Yes! This project was shared under the Creative Commons - Attribution license.
This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.
Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.