Ambiano Dehydrator Filament Drying Mod Adaptor - Ambiano Filament Trockner Dryer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple 80mm tall adaptor ring to convert the ambiano food dehydrator into an filament dehydrator.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 74
- Makes
- 0
- Views
- 589
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Filament drying mod for Ambiano food dehydrator
This is a simple, 80mm tall, adaptor ring for the ambiano food dehydrator. It turns the machine into an filament dehydrator. It fits almost all filament spools.
The holes are intentionally smaller and meant to be drilled out to fit an M3x10mm screw and nut.
Definately use a brim with 0mm model gap, otherwise your print will come loose. I used "3D Lac" on the PEI sheet for even better adhesion.
Use one original tray at the bottom and top of the adaptor for best drying results.
I printed it three times on an Bambu P1S and it fits perfectly.
Printsettings:
- Material: depends on the temperature you want to dry at:
- PLA (up to 50C)
- PETG (up to 70C),
- ABS, ASA (up to 90C)
- Wall Loops: 10 (so it prints as a solid piece)
- Layer Hight: 0.2mm / 0.3mm
- Speed: 120mm/s
- Support: only under the connector piece (see picture)
- Brim: yes